Used Okuma Axial Driven Tool Holder for CNC Lathes, to Suit Okuma LT15M CNC Lathe, ER32 collets. Eppinger 9.655.088, s/n 180929-1 1:1, 5,000rpm, VDI 40
Used BMT55 Angular Driven Tool Holder for CNC Lathes, Eppinger, s/n296625-6, model no. R78685, 1:1 ratio, max 6,000rpm Length of drive to Tang - 103mm, (To fit Doosan CNC Lathe)
Installation possibilities
The centric vice can be attached to the machining table from above using screws or clamps
The BSMG180 can be quickly upgraded to an RPCG180 zero-point centric vice simply by fitting a tightening bolt and two alignment bol...
Machining in a single setup
By operating with vices and clamps the workpieces are never completely free and it is necessary to use multiple placements to complete the processing cycle.
With MillTec the piece is always free on all 5 faces, allowing t...