Klamp DHP Pull Back Collet Chuck 80mm Capacity are suitable for collets which have a +/-0.5mm gripping range. Allowing the collet chuck to handle rough and unfinished bar, preparing it for a high accuracy second operation.
Due to the pullback nature of the DHP, it is only suited to bar work, the compact design means there is no position for a backstop.
Changing collets via a quick change gun reduces the change over time to seconds
CASER
07027
Drilling capacity on steel mm 50
Drilling capacity on cast iron mm 70
Arm lenght mm 1250
Spindle diameter mm 60-80
Spindle travel mm 350
Morse taper CM 5
Spindle speed 12 - rpm 30-2000
Spindle motor power HP 5,5
Approx. net weight Kg 3550...
With the use of seal kits leaks from the front of back of the cylinder can be stopped. The replacementf of the seals can either be done in house or can be sent to 1st Machine Tool Accessories for replacement by one of our technicians.
