Bandsaw Machine HFA250W
The Amada HFA250W automatic bandsaw is designed around the capability of the saw blade, therefore guaranteeing optimum cutting performance.
Utilising a 34mm wide blade the Amada HFA250W bandsaw machine has sufficient beam strength to enable it to cut any metal quickly and efficiently, up to its maximum capacity of 250mm, thus delivering an excellent cost-per-cut ratio.
NC Rear Vice
The rear vice is controled by an LED Programming unit situated on the control panel.
Number of cuts , tolerance, and auto trimming functions can all be set by the unit.
Up to 99 different programmes can be set.
Tolerance
The tolerance of the material to be cut can be set from +/- 0.1 to +/- 1mm
Auto trim cut
Material can be measured for the first cut from the front vice resulting in the trim cut being a cut component piece.
Pressure/flow feed control
The independent pressure and flow controls in series ensure that optimum cutting can be achieved regardless of the section or alloy being cut.
Drive wheel transmission
This is designed and built by Amada to provide high efficiency reduction, therefore delivering more power to the large diameter shaft. This ensures that developed torque is transferred to the blade.
Maximum cutting capacity
Round bar: 250 mm round bar
Rectangular bar: 300mm wide x 250mm high
Automatic, powered chip conveyor.
X/Y/Z 1050/600/600mmSpindle centre to column 680mmSpindle nose to table surface 120~720mmTable size 1100 x 600mmDimensions of T slotMax table load 1200KgSpindle Taper BBT-40Spindle Speed 12000RPMRapid feedrate X/Y/Z 20/20/1815” Colour display wit...
KSJ-04 Steel serrated soft jaws to suit a 4 Inch power chuck. Jaws are manufactured from 080M15 Steel. Good Quality of material allows for machining with a good finish.Jaw Finder
