These low profile cam action clamps and stops have a holding force of 3900N and have fingers that push the workpiece down before clamping, even on castings that have negative draft! The stops are mounted with special screws to ensure high precision locating. The spring steel clamping element rotates around an eccentric insert that provides 1.2mm of clamping in all directions. Stops and clamps are available in low profile and raised versions. The single stop with only one rigid stop is used for pieces over 44.5mm long. The double stop with 2 rigid stops is used for small size pieces.
Punching:Diameter x Maximum Thickness 33mm x 20mm. Maximum Diameter x Thickness mm 57mm x 12mm. Stroke Length 80mm. Throat Depth 355mm. Largest Hole Diameter standard 57mm. Largest Hole Diameter – Optional 160mm.Shearing:Flat Bar – Width x Maximu...
Cast iron plain cross profile Tooling Column with mounting holes. Plain to allow for the machining of hole patterns and features required for specific fixtures. Ground flat parallel and perpendicular for accuracy. Holes for side location to allow pre...