These low profile cam action clamps and stops have a holding force of 3900N and have fingers that push the workpiece down before clamping, even on castings that have negative draft! The stops are mounted with special screws to ensure high precision locating. The spring steel clamping element rotates around an eccentric insert that provides 1.2mm of clamping in all directions. Stops and clamps are available in low profile and raised versions. The single stop with only one rigid stop is used for pieces over 44.5mm long. The double stop with 2 rigid stops is used for small size pieces.
D120 Varibore hex collets are to suit 54mm capacity collet chucks. Also known as V120, these collets have a 3.175mm range. Supplied smooth as standard we can supply with alternate finishes and in special profiles.
D120 suit the following collet ch...
T-Nuts to suit BB200, BR & BRT Series Chucks
Used for the mounting of jaws onto the base jaws on a power chuck.
These are supplied with the bolts required.
Keeping spare t-nuts can result in reducing setup times.
The DK2-VT-B clamp has a self-adjustable steel ball inserted into both of the clamp jaws. The steel ball is equipped with torsion protection, allowing the ball to self-adjust up to 9 degrees. This makes clamping inaccurate parts and castings more fle...