Clamps, grips and stops, designed to be fully adjustable while mounted on T-Slot tables and grid plates. This system is designed around our Pitbull® Clamp which remains the strongest, lowest profile fixture clamp in the industry. Low-profile stops and grippers incorporated into design for less tooling interference and savings on material cost. These modular clamps and stops are ground to the same height as our Large Modular Pitbull® Clamp providing even greater versatility.
O Rings Pack
Rubber O rings to create an air and watertight seal between materials or objects. Suitable for sealing gaps between two surfaces. Includes assorted sizes from 4.2 x 7.2 to 15 x 23mm. Handy st...
For clamping different materials for the optionally three different clamping inserts are available. The use of teeth results in a high surface pressure whereby maximum holding forces are achieved. In the case of wear of the Mastergrip clamping claws ...
T-Nuts to suit B200, some BB200, BR & BRT series chucks
Used for the mounting of jaws onto the base jaws on a power chuck.
These are supplied with the bolts required.
Keeping spare t-nuts can result in reducing setup times.
Swing over bed dia 650mm. Standard turning dia 234mm. Maximum turning dia 260mm. Swing over carriage dia 365mm. Distance between centres 520mm. Bar capacity 66mm. Travels X/Z 50 + 130/400 mm. Rapid feed – X/Z axis m/min 30/30. Feed motor X/Z axis k...