Fully machinable aluminium jaws for use on either 0525 Qwik-Loks or 0525 Multi-Loks. The Dual Station Machinable Jaw Sets clamp with an equal and opposing inward force, thus eliminating the potential for jaw lift. The safe low profile jaw interface maximizes the amount of machinable area, giving the ability to hold larger parts. These jaw sets are available in standard size or oversize. An additional set of jaws can be created by purchasing an additional fixed jaw and reversing the movable jaws. All jaws are available as sets or individually.
SANGIACOMO
09943
C-FRAME PRESSES
Nominal force: 500 kN
Nominal stroke: 4.21 mm
Adjustable stroke: 12÷110 mm
Stop position: TDC
Ram adjustment: 70 mm
Stop time: 107 ms
Strokes per minute: 90
Maximum mould surface: 380x660 mm
Maximum closed mould heig...
NC24-L with 1000mm feeder NC24-LB with 2500mm feeder | NC24-LS versions with servo feed of the sawblade | Large capacity with linear blade feed system | Hydraulic feed of the saw blade carriage | Piece separation system to eliminate back cutting mark...
2 Way swing head for easy mitre cuts | Large width cutting capacity | Remote control panel | Manual blade tensioning with hydraulic gauge | Blade breakage detection with auto shutdown | Precision gauge for angle setting | Blade cleaning brush | Rolle...
