"NEWTON DEVICE DESCRIPTION\n\nM \u2013 Manual mode: Put the selector in M position (manual). Turn the apposite handwheel so that it matches the index with 0 (zero) indicated on the scale. In this way we tighten the saw balancing contrast spring. Lock the piece by closing the vice. Press the start button and go on with the normal manual cutting cycle: remember that the bow descent is activated only by pressing the start button. It is possible to adjust bow descent pression acting on flow regulator.\n\nD \u2013 Dynamic mode: Put the selector in D position (dynamic). Turn the apposite handwheel so that it matches the index with 40 (forty) indicated on the scale. In this way we loose the sawbalancing contrast spring. Adjust the limit switch at the end of the cut. Lock the piece by closing the vice, position the blade above the piece to be cut and press the start button. Now it is possible to adjust bow descent pression by means of the flow regulator: hence the bow go down by gravity autonomously. At the end of the cut the limit switch will stop the blade motion. Raise the bow above the piece and replace the bar to be cut.\n\nACCESSORIES UPON REQUEST:\n\nMicromist lubrication\nMRP pneumatic quick clamp kit\nLaser cutting indicator\nMechanical speed variator\nLoading & unloading conveyors\n\nDIMENSIONS: 1400 x 1500 x 1800 mm\nWEIGHT: 430 kg\n\nCutting capacity:\n\nRound tubes\n45\u00b0 sx: 160 mm\n0: 220 mm\n45\u00b0 dx: 200 mm\n60\u00b0: 130 mm\n\nSquare profiles\n45\u00b0 sx: 120 mm\n0: 190 mm\n45\u00b0 dx: 150 mm\n60\u00b0: 110 mm\n\nRectangular profiles\n45\u00b0 sx: 160 x 130 mm\n0: 330 x 150 mm\n45\u00b0 dx: 160 x 130 mm\n60\u00b0: 110 x 110 mm"
Year of construction: 1978 • Max. turning diameter over bed: 2500 mm • Max. turning diameter over support: 2000 mm • Max. turning length: 16000 mm • Max. workpiece weight: 100 tons • Main drive motor power: 120 kW
