TORGIM
TRN.PAG.O564
height of centre from table mm.400
height of centre from carriage mm.280
distance between frames mm.5000
bench width mm.415
notch width mm.450
Max swing over table mm.825
Max swing over notch mm.970
Max swing over slide mm.600
spi...
Genuine 60° slant bed for minimum distance from Z-axis ballscrew to the tool tip so as to reduce the chip build-up. Built-in 4-step gearbox inside the headstock further enhances the cutting torque 536.4kg-m at low spindle speed 67 rpm. Spindle nose ...
Conical (Morse Taper) Reduction Bush . These reduction bushes allow for the fitting of boring bars and drills with a tapered shaft. All sizes are manufactured in a range of capacities. The sleeves are hardened and ground for a good fit for both the h...