52" 4-Head abrasive belt/belt deburring and finishing system
with 51" maximum width capacity, 10" minimum part length,
and 0" to 6" part thickness capacity. Power raising and
lowering of the conveyor bed, with programmable thickness
setting with digital readout (stores up to ten thicknesses).
First Sanding Station: 8" diameter rubber covered contact
sanding roll. Driven by 30 HP motor with percentage of
motor load indicator display in the main panel. Abrasive belt
52" x 75". Pneumatic abrasive belt tensioning, Electronic
abrasive belt tracking. A cam adjusted contact sanding roll
is provided to allow for fine abrasive belts or ScotchBrite
sanding belts, without the need to adjust the material hold-
down rolls.
Second Sanding Station: 8" Diameter rubber covered contact
sanding roll. Driven by 30 HP motor with percentage of motor
load indicator display in the main panel. Abrasive belt 52"
x 75". Pneumatic abrasive belt tensioning, Electronic
abrasive belt tracking. A cam adjusted sanding roll is
provided to allow for fine abrasive belts or ScotchBrite
sanding belts, without the need to adjust the material hold-
down rolls.
Third Sanding Station: 8" Diameter rubber covered contact
sanding roll. Driven by 30 HP motor with percentage of
motor load indicator display in the main panel.
Abrasive belt 52" x 75". Pneumatic abrasive belt
tensioning, Electronicabrasive belt tracking.
A cam adjusted contact sanding roll is provided to
allow for fine abrasive belts or ScotchBrite sanding belts,
without the need to adjust the material holddown rolls.
Fourth Sanding Station: 8" Diameter rubber covered contact
sanding roll. Driven by 30 HP motor with percentage of
motor load indicator display in the main panel. Abrasive
belt 52" x 75". Pneumatic abrasive belt tensioning, Electronic
abrasive belt tracking. A cam adjusted contact sanding
roll is provided to allow for fine abrasive belts or
ScotchBrite sanding belts, without the need to adjust the
material holddown rolls.
Conveyor Feed: Variable speed conveyor drive, 15 to 45 FPM.
27" Infeed conveyor loading area with sheet metal emergency
stop extends across the front of the sander for operator
safety
Paper Media Filtration: Closed loop coolant system with
paper media filter mounted underneath the Sander for a
more compact foot print
Air Knife Dryer: Air knife dryer mounted on the outfeed
of the Sander, equipped with (2) Air Knives, (3) sets of
squeegee rolls, and an auto lubrication system.
The 41 Series (PUMA) is a complete machine with an integrated filtration
system to keep metal parts cool during machining, and adding lubricity
ensuring the abrasive belt's service life is extended. A high-pressure air
system dries the metal parts as they are exiting the machine. Removal of burrs
on laser, water-jet, punched, and cut metal parts. Provide the finest finish
in the industry Deburr, edge break, & finishing of metal in one pass Mixing of
metals, including titanium, aluminum, carbon & stainless steel, copper, etc.
Set of three replacement base jaws. Base jaws are normally replaced in the event of a crash. Please check the condition of slide ways in the chuck before replacing. Replacement of base jaws will not necessarily increase accuracy. Any damage or wear t...
