Amada PROTECTOR bandsaw blade exclusively for structural steel, rolled sections metal cutting
Exclusively for the structural steel, strong against tooth chipping and capable of providing unparalleled high efficiency. PROTECTOR added to the back face of the tooth tip prevents excessive cutting.
Suitable for: Construction Steel, Aluminium Alloys, Copper Alloys
M42 High-Speed Steel Edge
Unique Design Tooth Form
PROTECTOR added on the back face of the tooth tip suppresses excessive cutting and prevents continuous chipping from occurring.
Wide Set Available
Positive Rake Tooth Angle
Strong Tooth Profile
As the tooth tip is made stronger, it endures impacts caused during intermittent cutting. At the same time, high cutting efficiency is assured.
Set Design
The broaching style set pattern was designed to eliminate pinching, therefore preventing the blade from binding in the cut.
Wide Set Available
When a roll-formed large-size H-beam is cut, stress relieving may occur, pinching the blade. In order to prevent damage to the blade, a “WS” (Wide Set) type is available for PROTECTOR.
ADVANTAGES
Extra Tough Shock Resistance
Extra Tough Tooth Strippage Resistance
BENEFITS
Extra Fast Cutting on Structural Steel
Extra Long Life in Interrupted Structural Cutting
Low Cost Per Cut
The hardness of the Tooth Tip represent Amada’s average value. It is adjusted to some extent according to the types and size of the products.
* The WS (Wide set) type blade is a special saw blade with a measure against pinching which occurs easily when cutting the roll formed large size H-beam (applicable to H-beam whose width is over 400mm and mainly intended for that of 600mm or more width). The “PROTECTOR” WS type blade is a special saw blade with an intensified measure against pinching than the conventional WS type blade. Using of the WS type blade for cutting the material where no pinching would occur may shorten the service life of the blade.
Specifications may change without notice at the sole discretion of Amada’s Engineering Department.
Model 44 4” belt Tilting Table 3 Phase 415V Machine Serial Number: 14715 Cost: £950.00 + VAT Whilst every effort has been made to ensure that the above information is accurate it is not guaranteed. We advise prospective purchasers to check any v...
