"Bandsaw Machine HFA250W\n- Utilising a 34mm wide blade the Amada HFA250W bandsaw machine has sufficient beam strength to enable it to cut any metal quickly and efficiently, up to its maximum capacity of 250mm, thus delivering an excellent cost-per-cut ratio.\n\n**Features**\n\n**NC Rear Vice**\nThe rear vice is controled by an LED Programming unit situated on the control panel.\n\n**Number of cuts, tolerance, and auto trimming functions can all be set by the unit. Up to 99 different programmes can be set. Tolerance**\nThe tolerance of the material to be cut can be set from +\/- 0.1 to +\/- 1mm.\n\n**Auto trim cut**\nMaterial can be measured for the first cut from the front vice resulting in the trim cut being a cut component piece.\n\n**Pressure\/flow feed control**\nThe independent pressure and flow controls in series ensure that optimum cutting can be achieved regardless of the section or alloy being cut.\n\n**Drive wheel transmission**\nThis is designed and built by Amada to provide high efficiency reduction, therefore delivering more power to the large diameter shaft. This ensures that developed torque is transferred to the blade.\n\n**Maximum cutting capacity**\nRound bar: 250 mm round bar\nRectangular bar: 300mm wide x 250mm high\n\n**Automatic, powered chip conveyor**"
{"Cutting Control":"The cutting rate has been simplified by dividing materials into 9 groups when a particular material is selected the machine will automatically set the downfeed cutting rate and recommend the correct blade speed. Thus achieving max...
